The tarm 3 OUTDOOR are especially designed for outdoor laser installations. They come equipped with the top quality laser setup known from the standard tarm units, but have a waterproof enclosure that not only protects the components inside from water, but also shields off direct heat from solar exposure. A specially designed roof in front of the output window prevents it from getting impacted by direct rain. To cope with varying temperatures, the tarm OUTDOOR units are equipped with an active watercooling system, that is built into the housing. An active heating system helps to keep the laser systems operational even at low temperatures. Thus the tarm 3 OUTDOOR lasers can be used at environmental temperatures between -10¡C and +45¡C. A CT Scanner upgrade with LAS Turboscan drivers is available for the tarm 3 OUTDOOR to achieve top end quality graphics results.
The tarm 3 OUTDOOR show laser projector is a full color whitelight RGB laser systems with full analog color modulation and diode-only equipment. The guaranteed output power is specified at 3'000 mW after optics.
The tarm 3 OUTDOOR units have a built-in network DAC for Showcontroller, Showeditor, Touchdesigner, MadLaser, etc., but also can be controlled with any ILDA laser control software such as Pangolin Quickshow, Pangolin Beyond, LSX, Lasergraph DSP, etc. via external ILDA interface (e.g. FB3) and ILDA streaming. They also have a built-in memory with pre-set patterns, that can be easily triggered through ArtNet and automatic mode.
The tarm 3 OUTDOOR comes with integrated ShowNET network interface and free laser show software.